CALL 800-631-5708
1- SELECT A CONVENIENT- EASY TO REACH LOCATION ON DASH OF TOW VEHICLE
2- DRILL A 1/2" HOLE AND MOUNT TOGGLE SWITCH USING JAM NUTS
3- RUN CABLE FROM SWITCH TO REAR OF TOW VEHICLE SELECTING AN OUT OF
WAY ROUTE AWAY FROM EXHAUST AND ANY MOVING PARTS
4- FOUR PRONG PLUG AND CONTROL CABLE SHOULD BE TIED TO MAIN
ELECTRICAL CABLE WITH WIRE TIES
5- BEHIND THE DASH, THE WHITE WIRE FROM CONTROL CABLE SHOULD BE
CONNECTED TO A GOOD CLEAN GROUND
6- THE RED WIRE FROM TOGGLE SWITCH SHOULD BE CONNECTED TO A 12 VOLT
CIRCUIT ON THE ACCESSORY SIDE OF CIRCUIT OR FUSE ASSEMBLY